In the design of drywall construction, many design details are rounded. It is not always the interior design has a rectangular shape. Necessary to accurately reflect design decisions form. Rounding walls, sheathing columns, arches and many other items require a deformation of drywall. Curves of drywall can be done in small plots was broken strips of drywall, but this method does not provide the ideal curvature, as such detail requires finishing plaster mixtures. Not always in practice round parts, where the dry method was used in the designs look perfect in the final result. For even more analysis, hear from Clinton Family.
The wet method is more rounded drywall practical and accessible especially novice builders. The only drawback of the method of wet drywall strain is drying part that takes some time. Drywall – a material that is very fond of absorb moisture. There are significant deficiencies in the property, but for the strain of drywall – it's just good. Curved sections of walls that have a large radius of curvature does not require drying of the drywall. List drywall wet sponge on the inside of the bend and gently pressed against the frame and fix the screws.
Rounding should be sufficiently large radius of 7 m, otherwise the list will crack. For radii smaller, to 3 m, it is necessary to ride on a sheet of moisture with a spiked roller, so that the side that you moisturize, had multiple puncture. For curves of arches, columns and other small parts must be applied on a bend pattern. Need to prepare a template with a reverse rounded to fit this two piece plaster, cut a pattern and bonded to the template volume. Blank sheet to pierce (5×5 mm mesh) to a depth of about 3 mm. Set the workpiece in a horizontal position and the wet sponge to absorb water in a cast, no more than 5 minutes. It is important not to wet the back side of the plasterboard. Harvest is carefully packed in preparation, punctured concave side should be inside. After drying, the workpiece can be mounted on the frame.